 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Nordyne RL 90 Pressure Switch
Nordyne RL 90 will not start. Can see glow build in the ignition/flame chamber but then instead of blower starting, the unit would shut down instead. LED would blink I believe it was 3x (pressure switch was stuck closed) although I am not convinced it wasn't 4X. Pulled out switch, exercised it several times and then re-installed. All seems to work well. Would that likely be the problem or could there be something else yet that I need to be careful of?
|
||||
Check out some similar questions!
Nordyne pressure switch
[ 7 Answers ]
Red led lights indicate pressure switch is open, where is the pressure switch or valve?
Pressure switch on nordyne M1M
[ 3 Answers ]
I can't find the Pressure switch on my furance it's a nordyne m1m series
Nordyne furnace: no voltage to pressure switch
[ 3 Answers ]
Hi Folks, My furnace inducer blower goes on and stays on without igniting the furnace. The thermostat will not turn off the furnace, I need to physically switch it off. Brand: Nordyne Model: L1RA 090N 16B The circuit board does emit a single red led flash every few seconds:
Nordyne furnace pressure switch
[ 3 Answers ]
I have a Nordyne M1M furnace that is two and a half years old. A few days ago I turned up the heat on the thermostat and the furnace didn't come on. I looked inside the furnace and the LED light was flashing two times. The legend on the furnace says that two flashes indicate that the pressure...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
