 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Looking for an electrical schmetic with high and low voltage for heater and evaporator for RHEEM REAB 2020T with 617S heater.
Hello, after reading quite a bit I thought I had this wrapped up but I guess I don't. I am trying to wire up some baseboard heaters for the garage. I have run a 12/2 from the panel on a 20 amp double pole breaker which goes to a double pole t-stat (I want to be able to completely shut off the...
I have a pig tail made of type s cord with a dryer rec for one end and wire nuts for the heater end.. Using red wire nuts accepting 10 ga. Seems tight . Is this OK. Also should I use bx cable instead. I hope not because the so wire and 30 amp dryer plug were very expensive. I do not have a...
Is it safe to hard wire a 240v 15A Heater to a 30A 240V breaker? Are there any draw backs?
Hi All, I have a question about wiring my base board heaters. I am currently re-wiring my basement, adding a few heaters on the original 240V-20A circuit. It will be handling a total of 3500 W, no problem. The question is about the wiring itself, here's what I intend to do: Run from...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
