Ask Experts Questions for FREE Help !
Ask
    zahidk64's Avatar
    zahidk64 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 19, 2011, 09:16 PM
    York furnace
    Furnace comes on for a couple seconds. Then shuts off. But if power is reset it comes back on for a couple seconds again. Flame sensor? Gas valve?
    bobrenner's Avatar
    bobrenner Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Jan 20, 2011, 05:57 AM
    Flame sensor
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

How do you hook up a thermostat for a York furnace to the furnace? [ 3 Answers ]

How do you hook up a thermostat for a York furnace to the furnace?

York furnace [ 1 Answers ]

I have a York Furnace Model#: GY9S080C16DH11H with Serial #W0F5302743. I replaced the air filter and the unit started, but then quit after about 5 minutes. The small fan kept running. I opened the panel and the little light (usually green) was flashing (red) 4 flashes (meaning limit sw. open) and...

York furnace [ 1 Answers ]

I have a York furnace model # p2udd12p07601c. The problem I am having is when the funace starts up, occasionaly I can see the coil igniter light up and 30 seconds later or so the flame ignites by the igniter coil but only for a second and then it goes out without igniting across to the flame...

View more questions Search