Ask Experts Questions for FREE Help !
Ask
    ck4now's Avatar
    ck4now Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Jan 18, 2011, 10:18 AM
    Carrier Gas Furnace not enough heat
    Hi;

    I have a Carrier Gas Furnace that does not produce enough heat. I cleaned the filter and even replaced with a new one. Its still not produced enough heat.

    Sometimes, its attempt to ignite the flames several times before its successfully runs. If I set the temperature high between 20C-25C, then the flame lit-up right away, but if I set temperature below 17C then the flame will not lit-up right away.

    Any help would be greatly appreciated

Check out some similar questions!

Carrier Gas Furnace blower runs on/heat won't come on [ 3 Answers ]

I have a carrier gas furnace model 58DP100 . The fan runs continuously and the gas burners will not ignite ( the pilot is lit ) HELP... please .

Carrier 9200 Weathermaker gas furnace -- no heat [ 4 Answers ]

The furnace is about 5-6 years old, and advertised as "ultra-efficient". Gas furnace is inside, Carrier Tech 2000SS A/C is outside. Heat won't come on, despite my reset efforts: -turn thermostat to lowest setting -turn off all electrical power to furnace -remove access panel from furnace...

Carrier Natural Gas Furnace main gas valve will not open every call for heat [ 1 Answers ]

We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:

Carrier Gas Furnace, No Heat [ 4 Answers ]

I have a Carrier gas furnace weather maker, model 9200. When I turn the thermostat to heat, the induce drap blower is not coming on, but instead the ac and the main blower is on. When I check the power that is coming out of the PC board for the induce drap blower, I get 2 Volt.

Carrier gas furnace w/ no heat [ 2 Answers ]

I have just replaced my thermostat and now furnace blows cool air (fan on constantly), even with thermostat control in off setting. Followed all install directions w/ new thermostat To the letter. Is this a limit switch malfunction or what?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.