Ask Experts Questions for FREE Help !
Ask
    pinkshelby04's Avatar
    pinkshelby04 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 16, 2011, 04:20 PM
    Dyna Glo Kerosene Heater (RMC 95-C2)
    I just changed the wick in my heater and now the flame isn't as high as it used to be. I have changed wicks in this before but this is a first for not getting the full heat output out of this heater. Any suggestions would be greatly appreciated! Thanks.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jan 16, 2011, 06:59 PM
    Did you make sure to set the wick to the marked wick height? Let the wick soak well before igniting.
    DJ_Askme's Avatar
    DJ_Askme Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Nov 20, 2011, 09:17 PM
    Where can I order a drip tray for a Dyna-Glo RMC-95 heater? The part number is PS-CV32R1, but I can't seem to find it on line.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dyna-glo ventless gas heaters [ 0 Answers ]

I have a dyna-glo model RMC-40NGT, and the pilot went out. I followed thr relighting instructions, the pilot relit, but when I turned the knob to "on" the pilot went out. HELP! It's cold in here!

Dyna-Glo Kerosene wick won't stay up [ 4 Answers ]

I have a Dyna-Glo Kerosene (RMC-95-C2) heater, After attempting to change out the wick, I installed raised and it wouldn't lower. So I took it back apart. When I went to raise itagain, It would not. It doesn't click and immediately falls back to extinguished position. I haven't even...

How to replace wick in a dynaflo rmc-55-r7 kerosene heater [ 1 Answers ]

How to replace wick in a dynaflo rmc-55-r7 kerosene heater

View more questions Search