Ask Experts Questions for FREE Help !
Ask
    rdrakester59's Avatar
    rdrakester59 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 16, 2011, 09:24 AM
    How can I test my furnace fan timer control board?
    My Tempstar SP80 furnace blower will not come on. The fan timer control board clicks then makes a faint almost whistle noise but the blower never comes on. The blower motor checks okay. How can I test the fan timer control board to see if that is it?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
     
    #2

    Jan 16, 2011, 07:37 PM
    You can jumper from R to G on the control board if no blower you can remove the blower wires from the control board and add power. If it works you have a bad blower control.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bad Furnace Control Board? [ 6 Answers ]

I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...

Furnace fan/control board fuse issue. [ 1 Answers ]

I have a Bryant Plus 80V furnace (model # 315AAV0). I am having an issue with getting the fan go to high speed when using the Continuous Fan mode. I have the dip switches set to have it run on the highest setting and it still only spins at the lowest speed. Also about every few days the 3 amp fuse...

Humming from Fan Timer Control Module board? [ 6 Answers ]

I have A 6 year old Heil furnace model NTC6150kj, and a couple of weeks ago I noticed my Aprilaire humidifier was running even when the furnace shut off. The humidifier will not cycle on and off as it is supposed to. During investigation, I heard a fairly loud humming noise coming from somewhere...

Can I install a fan control board? [ 3 Answers ]

I am a broke, but resourceful guy who got a quote from an HVAC company to install a new fan control board in my Ducan furance for $420. He wrote to part numbers on the estimate. Ducane part 20430801 (Ducane) & ST9160B1076 (Honeywell). He told me it would take him 1-1.5 hrs to install. To make...

Power to furnace control board but stops there [ 3 Answers ]

Hi I was given a Nordyne KG6RA gas furnace. After installing, I turned on and there was a low hum when the power got to it. I held the door switch closed so I could see. After a few seconds there was a spark and then blue smoke and everything went dead. I could not see where the smoke came...


View more questions Search