 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a Bryant 330aav plus 80 code 14.
I cleaned the jets, the sensor and changed the filter. I would ignite once and heat up the house. Then the next time it would try to ignite and lock out. If you turned off the system and turned it back on it would ignite. This went on for two days. Now it won't ignite at all. It attemmpts then locks out.Please help!It's 20 degrees!
|
||||
Check out some similar questions!
Wanted to know if anyone could help me troubleshoot this problem.. This furnace will not fire up (every now and then), basically what happens is the igniter lights up, but will shut down after 5 seconds or so. It will do this three times until it goes into lock down, code 34 flashes. I reset...
I have a Bryant Plus 80 that is throwing a error of 33 (limit or flame roll out switch is open). The last time this happened was because the hot surface igniter was broken (frequent problem as my furnace has a tendency to short-cycle). I had picked up a couple extra ones so I had them on hand to...
Getting a code 14. 1st the system comes on. I hear the blower going for about 90 seconds. 2nd the blower wheel spins and eventually I start to smell gas. The unit clicks 3 times but the ignitor never comes on. That's when I get a code 14.
I have a Bryant Model 330AAV Upflow- the flashing indicator lights say it could be a Pressure switch, Draft safeguard switch stuck, or low heat pressure. How do I determine what the problem is?
Hi My furnace stopped working this morning. It's 8 degrees here in Michigan... brrrrr. :( I checked for an error code but the LED light was on continuous. The problem was that the furnace was on (flames going) but the fan would only stay on for about 2 minutes and then turn off. I had...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
