Ask Experts Questions for FREE Help !
Ask
    bud10's Avatar
    bud10 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 9, 2011, 05:54 AM
    Boiler ignites then goes out after 10 seconds trisave turbo 45

Check out some similar questions!

Hot water heat - boiler runs for 15 minutes then cycles on and off every 15 seconds [ 0 Answers ]

Sounds like it is lighting the boiler over and over again. I thought it might be a dirty flame sensor so I used some light sandpaper on the flame sensor but did not reolve the problem. It is a Slant/Fin Victory II Boiler Model VHS-120 EP. Thanks for your help.

Why is there a loud booming noise when the igniter ignites my gas boiler [ 1 Answers ]

It's almost like there is a build up of gas... the furnace otherwise runs great

Gas furnace ignites, then goes out within 15 seconds [ 2 Answers ]

Last winter I had a hot plate igniter replaced. Near the end of spring the igniter would ignite the furnace and after 10 to 15 seconds, the flame would go out. About a minute later the hot plate igniter would glow, the gas will ignite for another few seconds and go out. After several cycles the...

Gas furnace ignites intermittently-ignites after removing cover from ignitor chamber [ 3 Answers ]

Unit: Carrier WeatherMaker 9200 gas furnace, with an HSI ignitor Symptom 1: Thermostat is calling for heat, as evidenced by a flame icon on thermostat face, but no action in the furnace. Symptom 2: Ignites only AFTER I initiate Action 2 below. Then it seems to work for a while, until the...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.