Ask Experts Questions for FREE Help !
Ask
    GSTARR7's Avatar
    GSTARR7 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 7, 2011, 01:12 PM
    NO led light on the Hot Surface Ignition board, Does this mean it is bad?
    My gas furnace won't turn on. Just replaced the upper limit switch with a different kind? Will that make a difference?
    Please help!

Check out some similar questions!

I am not getting 115 AC volts at surface igniter. Is this a controller board problem? [ 12 Answers ]

Draft inducer works, pressure switch works, rollout switch works, surface igniter (41-404) is not lighting up. Igniter itself measures 60ohm which should be OK. On surface igniter feed lines I am getting 6 AC volts instead of 115V. If this is control board problem? how difficult is to change?...

Why the fast flashing LED on new board? [ 3 Answers ]

I installed a CESO 110057-02 board on a Bryant 373LAV product and the trouble code reads fast flashing for reversed polarity or twinning problem. Reversing the polarity had no effect. There is no twin. 24 VAC transformer replaced. Blower only comes on. Any help appreciated, Vern

Led on york control board [ 2 Answers ]

My furnace blower motor is not working. Capacitor checks good. Outside unit runs. Noticed the LED blinks once, go's off and blower will not come on. All was good last Night. Shaft turns free. Any ideas. Thanks

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.