Ask Experts Questions for FREE Help !
Ask
    wwoodstrom's Avatar
    wwoodstrom Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 5, 2011, 10:20 AM
    Taking cover off Honda HS35 Snowblower
    "I went to start my Honda HS35 Snowblower the other day and the recoil cord came untied and the cord came straight out. I think the recoil is fin, but I cannot seem to get the plastics covers off to get at the recoil. The top red plastic cover has four bolts and it should come right off, but I can't get it around where you put the gas in. Is there a way to take the neck off where you put the gas in? If you have any other suggestions it would be appreciated. Thanks"
    payitforward2's Avatar
    payitforward2 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Jan 24, 2016, 03:49 PM
    I believe the main shroud is attached with 5 bolts (the 5th bolt is lower down on the right side - opposite side from the drive belt). To lift the shroud over the fuel neck you need to remove the gas cap then gently remove the rubber gasket from around the neck (either spin it off counter-clockwise or flip over the lip and pull straight up). I also have a question... how to remove the knobs for fuel and on/off? The choke has a set screw that is underneath the collar of the knob, but I cannot see how the other two knobs are held in place.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honda HS35 snowblower starter cord [ 2 Answers ]

The starter cord came out after a couple pulls. It used to work great. Since the cord not broke there is sufficient cord to use the same cord. I have it all apart and see the spring tightens when I turn it toward the front of the machine. Where do I install the cord and how exactly does it get...

Honda HS35 Starting problems [ 6 Answers ]

I recently bought a used Honda HS35. The first two times I used it, it started fine. After the last use the engine start switch was accidentally left in the on position for about a week. Since then I have not been able to start the engine... it doesn't even try to start. Checked the plug and it is...

Honda HS35 won't throw snow [ 3 Answers ]

I have a Honda HS35 snow blower that won't throw snow. The rubber blades are a bit worn but I would think it should throw something. The machine also operates at a fairly low rpm and when I raise the rpm it will throw snow but just enough to get past the discharge chute. I want to buy new...

Honda HS35 4 Stroke Snowblower truble. [ 2 Answers ]

My Honda HS35 4 Stroke Snowblower won't work, it'll almost start, but won't. Have any ideas? Please help!! :(

Honda Hs35 snowblower [ 1 Answers ]

Hi There; My hubby just picked up (literally) a decent looking blower. All of ours previously have been attached to tractors. I was wondering if anyone out there might have a manual they were no longer using or an unwanted spare manual to assist. He's good, but sometimes gets frustrated with...

View more questions Search