9hp B&S vac/chipper

CLS07 Posts: 1, Reputation: 1

New Member

Jan 4, 2011, 01:03 PM

9hp B&S vac/chipper

Oil pours from rubber tube. Oil overflow valve? When throttle is on max,not at halfway. Engine will drain itself of oil. On 9hp Briggs and straton craftsman vac chipper

Check out some similar questions!

I need 110 vac for my circuit. But main supply gives 220 vac supply. [ 0 Answers ]

I belong east side country not west. So how can I split my main supply into two 110vac supply for my circuit. I will thankful.

Troy-Bilt chipper/vac 5hp fuel problems [ 1 Answers ]

I have not used my chipper/vac for a couple of years as it had become really difficult to start & I would get fustrated. This is a 5hp model with a Tecumseh engine. I had another go today. Checked fuel initially and was surprised to see the tank completely empty. Filled it partly up and then...

Sweeper broom/stick vac or canister vac? [ 3 Answers ]

Which do you think would be best for hardwoood floors, sweeper broom, stick vac, or canister vac? Or just a plain old broom... I hate how the dust swirls in the air from a broom. Thanks

I have a 3-wire 240 VAC power box, and would like to install a 120 VAC outlet from it [ 4 Answers ]

Do I just take power from one leg and ground? If so, how do I ground the outlet?

Yardman chipper,shredder, leaf vac [ 3 Answers ]

I have a Yardman (MTD 5.5 horse) chipper, shredder, leaf vac that is self propelled. I need to replace the drive belt but don't know how to remove the propeller to get the belt off. The model # is 247-203B401, '97 model. Can anybody shed some light on this ? Thanks.

View more questions Search

Check out some similar questions!

Add your answer here.