 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
I've raised this issue in other forums. I have a high efficiency furnace that has worked flawlessly for the last four years (the house was built in 2000). This year we had to have the circuit board replaced. After that there was a problem with the blower, i.e. it wasn't shutting down after the...
I have an outside wood furnace the blower on the inside furnace won't run I have the blower hooked up to a extension cord teporarely so the baby's don't freze can I posibly reset the limit switch or do I need to replace the inside furnace is old and I don't know about matcing parts I'm only usining...
The blower is running but not putting out any heat
I have Bryant upright furnace (Model 394GAW048100). Furnce runs fine for the first 4 or minutes in a cycle and then gas is cut automatically while the pilot is still on. After a few seconds, the gas again comes on and Furnace works fine for about 30 seconds, again gas is cut and so on. I changed...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
