Ask Experts Questions for FREE Help !
Ask
    ElJameso's Avatar
    ElJameso Posts: 13, Reputation: 1
    New Member
    		  
    #1

    Jan 2, 2011, 01:39 AM
    What is the best way to make a 3 inch hole in stanless steel?
    I constantly have to drill 3 inch holes in 1/8 inch thick stainless steel. I currently use a high power corded drill and a 3" bi metal hole saw, drilling slowly and applying cutting oil as needed... It takes a really long time, I go through tonnes of hole saws, and it's really aggravating. Does anyone know of a better tool for the job?
    peterbranton's Avatar
    peterbranton Posts: 123, Reputation: 2
    Junior Member
    		  
    #2

    Jan 17, 2011, 07:51 AM
    You could easily make yourself up a press which would be the cheapest option, or if you have money to burn a plasma laser and computorized set up the you can just leace it to the job
    Dr1757's Avatar
    Dr1757 Posts: 186, Reputation: 25
    Junior Member
    		  
    #3

    Jan 20, 2011, 11:17 AM

    I agree with Peter, a plasma cutter or a 3 inch die used in a hydraulic press would simplify the process.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Above ground pool with 4 inch hole in the steel wall. [ 1 Answers ]

I had a very small leak in my liner about just under the water line. Over time it created a 4inch diameter hole (rusted) in the wall. The liner is now concaveed and being sucked into the large rusty hole. Can I repair the wall bey draining the pool, drill holes in the wall and bolt a small sheet of...

Drill Hole in Stainless Steel Sink [ 30 Answers ]

How do I drill a 3/4" hole in a stainless steel kitchen sick?

How can I move my steel toilet drain an 2 inch [ 2 Answers ]

My House is very old and I Have a steel drain. I need to move my toilet 2 inch because the shouwer is too close to the toilet. How can I move it without digging too much?

Drilling 3 inch hole [ 6 Answers ]

I want to hollow out a pine log about 5-6 inchs wide. I tried a 3 inch forstner bit and it just will not do the job effectively. I only want to go down about 5 to 6 inches as well. Any suggestions?

What makes a 1/8 inch hole in ceiling sheetrock? [ 1 Answers ]

This little bugger is in my finished garage ceiling. It has a vaulted roof to the space above the ceiling sheet rock is about 6 inches and insulated. There are two small holes just along the ridge beam rafter, where the sheetrock and wood bean join. Out of these two 1/8 inch holes comes small...

View more questions Search