Can a blower motor model DL1056 be wired to straight power ?

firehog Posts: 1, Reputation: 1

New Member

Dec 28, 2010, 11:17 AM

Can a blower motor model DL1056 be wired to straight power ?

wmproop Posts: 3,749, Reputation: 91

Ultra Member

Dec 28, 2010, 12:30 PM

Sure, as long as its wired to some kind of a on/off switch and has the correct capicitor connected to correct wires

Add your answer here.

Check out some similar questions!

New blower motor - Rheem furnace model # rgda-07ea-cr, 75,000 BTU. [ 9 Answers ]

Hi - I have a 1987/88 Rheem furnace model # rgda-07ea-cr, 75,000 BTU, natural gas. The blower motor is starting to get noisy and vibrate. I pulled it out and took it apart and looked at the bushing and shaft and see the shaft is wore, so thinking there is not use just replacing the bushing. ...

Ge dryer, model #dpgt750ec1pl blower motor [ 0 Answers ]

Blower motor motor does not run. On start up blower motor just twitches back and forth slightly. Is the motor bad or the inverter bad? Thanks

I have a 90 Plus furance/air unit. The blower motor locksup when power is applied. [ 1 Answers ]

How do I check to see if there is another problem besides the motor? When power is applied to the motor it locks up like it is single phasing. I do have a VOM meter. Is there a way to check the relays, board and capacitor to see if they are what caused the motor to burnup. It smells bad although I...

Blower motor power [ 1 Answers ]

Hello , I have a magic chef furnace that was working and all of a sudden quit. I am getting power to the furnace, and motor is good because I removed motor and had it professionally tested. I was not getting power to blower motor but could hear the click from the relay, I tried both...