Ask Experts Questions for FREE Help !
Ask
    hondamanas's Avatar
    hondamanas Posts: 5, Reputation: 1
    New Member
    		  
    #1

    Jan 10, 2007, 01:57 PM
    What is igniter? Honda civic
    Hello. Could you explain me about igniter. What is that? I did not find about that in my manual book . Can I test it before changing and how? Thank you a lot for helping. :)
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jan 10, 2007, 03:31 PM
    Controls sparking; i.e. when the coil's magnetic field builds up and collapses. Here's what they look like:

    http://www.partsamerica.com/ProductL...Control%20Unit

    Autozone will test them for free.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

91 honda civic [ 4 Answers ]

I have a 91 honda civic 4 door sedan dx. I just replaced the rotor and distributor cap and now the car won't start. First I checked multiple times to be sure I had the firing order correct. I then read the thread written by CroCivic91 and checked my ECU codes. I got a 10 and 16. The 16 sounds...

91 Honda Civic [ 3 Answers ]

Engine runs rough - a lack of power but not a hard miss - until engine warms up but car must sit for at least 18 hrs. 170,000 miles. Replaced plugs, cap rotor - no help. Distributor shaft has minor oil leak allowing oil to get inside of cap - maybe related.

92 honda civic [ 1 Answers ]

My Civic will not start. When it was running it made a rumbling sound like dut dut dut dut. So I change the spark plugs, the wires, the distributor cap and the rotor in the distributor. Now the car will not start and when I try to start it it will get to the point where it will almost start it...

91 honda civic [ 1 Answers ]

When I start my car it makes a loud and constant grinding noise it recently had the oil drained and was sitting without oil for about two weeks?

ECU input to Igniter (ICM) on 1993 Honda Civic DPFI [ 0 Answers ]

How do you measure the input from the ECU to the ignitor (ICM) (YEL/GRN wire)?? This input tells the ignitor when to ground the -ve side of the primary coil. My multimeter registers a non zero small voltage when cranking, but since the response is very low on my meter, I don't think I'm...

View more questions Search