Ask Experts Questions for FREE Help !
Ask
    wardbrothers's Avatar
    wardbrothers Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 18, 2010, 06:21 PM
    2000 ford 7.3 diesel won't start
    My friend has a 2000 ford f-350 with the 7.3 engine a in the coldest days of the winter the truck will only start if you do the following 1 crank the heck out of it 2 starting fuild but I told him that's not a good idea 3 pull in the block heater for two hours and it will start but you have too keep your foot on the gas pedal or will die sometimes in the summer months it will start fine soon as it gets cold yes you got it won't start but if you keep cranking it the oil preasure gauge goes up and it will soon takes off got any answers on this

Check out some similar questions!

2000 Ford F350 7.3 Diesel [ 0 Answers ]

Got several codes of 1211, 1212 and 1282 on superchip flashpaq. Truck won't crank.

Ford f350 2000 turbo diesel,is mixing diesel in to the cooling sistem [ 1 Answers ]

Ford f350 2000 turbo diesel,is mixing diesel in to the cooling sistem(with antifreeze) nothing with the oil.the engines is working properly.I remuved from the radiator one gallon of diesel.what kind of problem my truck has.

2000 ford f250 diesel wiring glow plug locations [ 1 Answers ]

I have a 2000 F250 crew cab 7.3 diesel. I found a connecter plug just dangling around my right wheel-well. I noticed that it fed off the harness coming from the fire wall connecter that plugs in next to the blower. I cannot find where it belongs, anybody have any ideas? One of the wires has a red...

2000 ford f250 diesel wiring glow plug locations [ 1 Answers ]

I have a 2000 F250 crew cab 7.3 diesel. I found a connecter plug just dangling around my right wheel-well. I noticed that it fed off the harness coming from the fire wall connecter that plugs in next to the blower. I cannot find where it belongs, anybody have any ideas? One of the wires has a red...

2000 ford f250 diesel manual transmission issue [ 1 Answers ]

My clutch quit working, no signs of slipping or nothing. I was told it was probably the slave cylinder so I replaced it and nothing so I replaced the master cylinder and it still didn't work. So I took it to a local repair shop he pulled the tranny and found the arm that holds the trow out bearing...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.