Goodman furnace status codes

rgalo10279 Posts: 1, Reputation: 1

New Member

Dec 16, 2010, 07:39 AM

Goodman furnace status codes

Status light flashes 3 times - What does that mean?

parttime Posts: 1,440, Reputation: 113

Ultra Member

Dec 16, 2010, 10:30 AM

Remove the cover and look at the legend, should show all the codes. Good luck

Add your answer here.

Check out some similar questions!

Goodman furnace trouble codes [ 4 Answers ]

I have a 5 year old goodman 92 that is giving me 5 blinks on the main circuit board. It goes through the start-up routine and after about three attempts the burners will stay on. What does that really mean?

Goodman furnace troubleshooting codes? [ 7 Answers ]

Have a goodman gas furnace it cycles through once and then makes a pop sound? It then gives a blinking code of 1 blink is this the gas valve?

Goodman furnace fault codes [ 3 Answers ]

Hello ! I am an auto mechanic, so when it comes to furnaces, I know nothing, but I have been learning about my furnce today. I have a goodman GMP-150-5 furnace that when the thermostat turns it on, I haer the draft fan start and run and after about 5 minutes, it just shuts down. Now, I looked at...

Anyone know the diagnostic codes for a goodman furnace? [ 3 Answers ]

Hi, I have an older model goodman furnace that powers up the vent fan and proceeds far enough in the sequence for the electric igniter to glow, but then never releases gas to complete ignition. I replaced the gas valve last year, so I am hoping it isn't this again. I am getting an error code on the...

Goodman Furnace - Won't Light, No Codes [ 3 Answers ]

Eleven year old Goodman gas furnace. The main vent blower will start, but that's where things end. The draft inducer motor doesn't start and nothing else in the chain obviously happens after that. The LED on the board stays red and never flashes any codes. I checked the voltage coming into...