Ask Experts Questions for FREE Help !
Ask
    Chaag45's Avatar
    Chaag45 Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Dec 11, 2010, 07:38 AM
    I have a nordyne furnace.
    I have a Nordyne Furnace. Model # M1MB070BW. I'm thinking I may need to replace the Flame Sensor on it. But I cannot locate one on this furnace. We just replace a gas valve on this furnace. It lights up for just a few seconds then the flame goes back out. Can you please give me a idea of where the Flame Sensor would be on this furnace.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Dec 11, 2010, 11:07 AM
    Not often the senser needs replaced,but maybe, it should be mounted on the left side of burners close to where flame is.. It has only one (1) wire going to it,, remove and clean real good with very fine sandpaper or steel wool
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Nordyne furnace repair [ 6 Answers ]

I have a Nordyne Model g5rk120c-20. The blower runs and the burners ignite. After about 3 seconds the burners go off. The cycle then repeats itself. Any thoughts?

Nordyne electric furnace [ 0 Answers ]

I tried to install a relay to bring on my blower motor which is a good motor. However I have 24 volts that energizes the relay therefore closing the high voltage circuit going to the blower. The common leg is still going to the breaker and the speed tap is hooked to my relay. However the blower...

Nordyne Furnace thermostat for A/C [ 7 Answers ]

I have an older nordyne Furnace and am trying to install central air. My question is hooking up the thermostat, there are no wires to add on for a 4 wire system, do I need to install the optional transformer for this like the wiring diagram shows? Thanks

Nordyne electric furnace [ 1 Answers ]

I have a Nordyne 2 stage electric furnace model E1EB-015H we changed the thermostat 3 years ago using a Honeywell RTH8500D. Since this was done we have had trouble every year. I have had Technicians out each season to work on the unit and they get it working until it is time to change from heat to...

Nordyne Furnace not working [ 27 Answers ]

Nordyne Furnace Model # L1RA 045N-08A. Blower runs constantly, whether the thermostat is on; no flame, no ignition, no heat. Have to unplug furnace to stop the blower. Red status light just steadily blinks on and off, not in a particular cadence. HELP! What do we do? Unit is still under...

View more questions Search