Ask Experts Questions for FREE Help !
Ask
    mr_driver's Avatar
    mr_driver Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 10, 2010, 10:29 AM
    Leeking coolant how to fix
    I have a 88 lincoln towncar just got new raditor water pump and thurmstat but it is spraying out the back side of the engen can a block seal fix that
    smoothy's Avatar
    smoothy Posts: 25,490, Reputation: 2853
    Uber Member
    		  
    #2

    Dec 10, 2010, 12:42 PM

    You need to find out exactly where its leaking from... a gasket or a freeze plug. Either really need repaired properly if you expect to hang on to the car as both can suddenly give out if not worsen. Any sort of sealer is going to be temporary at best in this situation.
    chefpierce's Avatar
    chefpierce Posts: 56, Reputation: 3
    Junior Member
    		  
    #3

    Dec 26, 2010, 02:59 PM
    Smoothy is right... but it might have been installed improperly.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My boobs are leeking but I'm on my period why? [ 1 Answers ]

I'm only 18 and I'm on the pill but I notied this morning that my boobs are leekin like a misty water dey aav got slightly bigger and are a little tender but I'm also on my period so that's why I fort it was very strange I don't understand why its doing it could I be preganat even though I'm on my...

Coolant level [ 5 Answers ]

Hi I topped up the engine coolant level with a 2 water to 1.5 antifreeze yesterday and I kind of went over the maximum level by roughly an inch. And today when I parked up I noticed alo of steam coming for my engine so I lifted the bonnet and it seems the pressure had popped the cap of the coolant....

Leeking sprayer [ 2 Answers ]

My kitchen sprayer leeks, what causes that and how do I make it stop leaking

Leeking basement wall [ 1 Answers ]

House was build in 1909. First four courses are glazed tile blocks above that there are cinder blocks. The tile blocks are hollow and the morter joints are in poor shape. The edges are glazed so the sand morter did not hold. I've used hydraulic cement to repoint them. I repaired all open joints...

Can I fix hazardous steps if a contractor is refusing to fix, and threatens to sue? [ 1 Answers ]

I live in central Texas. I hired a landscape contractor to install retaining walls and a patio which included 4 steps in stone. These steps range in size from 6.5" to 9.5" and the tallest is on the top! They are very dangerous. He refuses to do any fixes, and walked off project. At one point in the...

View more questions Search