Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Slab on grade shower pan support
[ 4 Answers ]
I am installing a 3'x3' shower in the basement on a slab-on-grade. I have "blocked out" a 15" x 15" x 15" recess in the slab (which has been poured). It has the 2" PVC drain pipe coming out of the side of the hole to which the trap will be attached when the exact location of the shower is...
My shower drain is raised above the shower pan by 3/16" causing standing water
[ 2 Answers ]
I have a fiberglass shower stall where the bottom has either slumped or the stall was installed wrong to begin with (it has no support beneath the surface that I stand on). The drain sticks above the level line so I have about 3/16" of standing water. I cannot easily access the bottom from the...
Installing custom sized shower pan on concrete slab
[ 1 Answers ]
I am removing an existing fiberglass shower unit to replace it with a larger, custom-built ceramic tile shower. The subfloor is a post-tension concrete slab. I will not be able to move the drain, so it won't be centered in the new shower floor. I'm Ok with having an off-center drain. But, all...
Shower pan on slab
[ 1 Answers ]
My specific question is in installing new plumbing under a slab. When I pour the floor repair, I will set the drain in the slab repair. Can I also do the first sloping for the vinyl pan with this repair, spreading the concrete and mortar out to the edges?
Removing a Shower Tile Pan on a concrete slab (Basement)
[ 3 Answers ]
I am trying to figure out the best way to remove a tiled shower pan from my shower in the basement. I am planning on replacing the floor pan with a pre-fabricated version. I am presuming that I remove the existing tile with a chisel and hammer, my concern is how do I make the area level once I... View more questions Search
|