When having new boiler installed should a new valve (main) be replaced?

Check out some similar questions!

We had a check valve installed on the main sewer line near the plumbing stack to prev [ 5 Answers ]

Just a quick question.

I'd like to install a ball valve on main water line will a "Viperlok" valve work? [ 1 Answers ]

I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....

Why the check valve installed on the discharge, but not installed on Suction [ 2 Answers ]

Why the check valve installed on the discharge, but not installed on Suction?

Boiler on and off after thermostat replaced [ 4 Answers ]

After replacing the thermostat, I raised the temp setting to check that it was working. Seems to work but once temp is reached, the boiler start to shut on and off every few seconds. I let this run for a few minutes to see if it would stop, but after a while I just reduced the temp setting to...

Gas valve noise on main valve engagement [ 1 Answers ]

I have a carrier 58gs100ga furnace with a white rodgers 36e93 gas valve. The main gas valve solenoid chatters or rattles for a split second before it stays engaged after the pilot is proved. I just replace the spark/lock out board and the fan board for a different problem. This chatter is...

View more questions Search

Check out some similar questions!

Add your answer here.