Check out some similar questions!
I have a Bryant 355AVV Furnace I want high-heat instead of low heat, what switches?
[ 0 Answers ]
I have a Bryant Gas Furnace Model 355AVV. It usually runs on low-stage heating if I have the temperature set to 74 degrees F. When it gets colder it doesn't seem to go to high-stage heating very often unless we turn up the thermostat to a much higher setting. It's like it isn't aware that the...
Coleman electric furnace/heat pump. When elec heat comes on, it will not shut off.
[ 1 Answers ]
Last week when I got up for work I noticed the house warmer than normal. I found the electric heat strips still energized. Tstat was set for 70 house was 74. I do hvac work but deal with air handlers, chillers and small boilers, only residential when its mine. Anyway, I asked the guy at Johnstone...
Furnace No heat
[ 2 Answers ]
After my furnace runs and heats the house, sometimes the charging motor keeps running, it's a hot air propane furnace. The house will cool off and furnace won`t start unless you shut the thermostate off and reset it. I installed a new ignition control and a new thermostat. The problem still...
Furnace heat
[ 1 Answers ]
Furnace will not stay lit. light goes on and off and when it does I hear a clicking noise. Is my sensor bad?
Furnace comes on but the heat goes off after a while
[ 1 Answers ]
I have a Lennox 4 wire system furnace and I purchased a Noma thermostat. I currently have White,Green,Blue and Red wires. Based on the advise I got online so far, I've bridged the Red and White wires and I'm getting the heat. This is just to test and make sure that the furnace is OK. I still needs... View more questions Search
Add your answer here.
|