Ask Experts Questions for FREE Help !
Ask
    reo789's Avatar
    reo789 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 3, 2010, 10:44 AM
    I have a williams wall heater.
    I replaced with non programmable digital thermostat. I connected the two wires correctly. I turn pilot on but when I turn the thermostst to the temp I want the pilot turns off. Any I deas? Should I get a new old style thermostat. The old one would work if I put a screw driver tip on the contact points. Help.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Dec 3, 2010, 05:24 PM
    Sounds like you have low gas pressure to me.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My Williams Nat Gas Heater Pilot will not lit up [ 0 Answers ]

However hard I tried to keep the pilot knob pushed in, I cannot get the burner inside heater to lit up (forget staying lit - it does not lit up at all). This is just the second year with the heater - so quite brand new. Gas seems to be on, because I can get the heater working in a different room....

I have an old wall gas heater that is depositing a plume of gray on the wall above [ 1 Answers ]

This old wall gas heater, about 60's, is depositing a plume of gray on the wall and onto the ceiling above the unit. The service man has already told me that they is nothing that can be done about the soot/discoloration on the walls in the room. He assures me that the gas heater is working...

Gas wall heater pilot light is lit but heater does not come on [ 2 Answers ]

My gas wall heaters pilot light is lit ,but the heater does not come on even if I turn the thermostat up to 100 degrees?

I am thinking of installing a Natural Gas Williams Monterey Top-Vent Wall Furnace, wi [ 1 Answers ]

I am thinking of installing a Natural Gas Williams Monterey Top-Vent Wall Furnace, with 35,000 BTU In my finished basement. I have three heat registers but the temperature in the basement isn't as warm as we would like especially when its below freezing out. My question is, since the wall...

Wall heater pilot light lit, but cuts off when I turn heater on [ 6 Answers ]

I have a wall heater, the pilot light was out so I re-lit it a couple days ago and it went on.. about 4 hours later I noticed it was out again... same thing off and on for three days... this time I lit the pilot and turned the heater on it immeditly made a click sond and went out completely... it...

View more questions Search