Ask Experts Questions for FREE Help !
Ask
    dylansdadlv's Avatar
    dylansdadlv Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 30, 2010, 09:13 PM
    I am looking at this carrier furnace and the blower keeps running .
    I replaced both limits and the control board.This unit does not have an IDM.Could the heatexchanger be corroded and not allowing the proper amount of heat to escape keeping the blower on in default?
    mgliue's Avatar
    mgliue Posts: 29, Reputation: 1
    New Member
    		  
    #2

    Dec 1, 2010, 08:10 AM
    MMMM. Please, start by the beginning... why did you decide to change the limits, try to explain better your problem... what is an IDM for you? Thanks
    dylansdadlv's Avatar
    dylansdadlv Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 1, 2010, 09:10 PM
    Comment on mgliue's post
    Upon further inspection found that heat exchanger was corroded and beginning to separate.I also would not doubt the coil is plugged also.Without an Induce Draft Motor the vapors and excess heat caused the heat exchanger to over heat tripping the lim
    mgliue's Avatar
    mgliue Posts: 29, Reputation: 1
    New Member
    		  
    #4

    Dec 2, 2010, 09:29 AM
    Be careful! Do not use the furnace anymore... a cracked exchanger allows combustion products pass into your room CO included. So I suggest you to replace your furnace TODAY. There is no way to repair a corroded-broken exchanger. Take care. Miguel
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

Carrier furnace blower will not shut off [ 7 Answers ]

I have a 13 yr old Carrier Weather Maker 8000 gas furnace. It heats fine. However, earlier this week, after reaching the set temperature, rather than shutting off the blower kept running, eventually blowing cool air. What's crazier, even after switching the thermostat (a programmable type) to Off...

Carrier furnace blower will not stay on [ 6 Answers ]

Hi Everyone: First time user here, so be patient! My Carrier furnace (model 2BR0024000; serial number YA24575) clicks, the igniter ignites and the burner comes on, only to run for a few seconds before the blower shuts off and the furnace shuts down. I am unemployed and cannot afford an unnecessary...

Carrier package unit blower fan turning off while compressing keeps running [ 2 Answers ]

I have a Carrier 50ZPA package unit 1.5 years old. In the winter, the blower would come on by itself without the compressor engaging. Now in the June-July Summer, The compressor comes on but the blower fan just shuts off and does not come back on. The compressor keeps running with the blower fan...

Carrier 58pav blower motor running too long after gas [ 4 Answers ]

Hello if someone can help me it would be great Ihave searched and found so many different reasons but I would like the best help I can get. It's a carrier 58pav my parents installed in Feb 1999. After the gas turns off, the blower runs for a few minutes, pulling cold air from outside. I...

View more questions Search