Ask Experts Questions for FREE Help !
Ask
    NanSea's Avatar
    NanSea Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 28, 2010, 03:05 PM
    How to replace the existing wall outlet that is attached to a wall switch?
    I wanted a new type of outlet. A friend said that he could change it. He did. The outlet works, but it doesn't work with the wall switch like it did before the new one. I know the wires are connected wrong... what's right?
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
     
    #2

    Nov 28, 2010, 06:05 PM

    Need to know what wires are in box. How many cables and number of wires coming out of each cable and colors. Then we will be able to help u.

    Chuck
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
     
    #3

    Nov 29, 2010, 09:53 AM

    Did you break the connecting lug behind the screws?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ceiling light using existing wall switch that currently controls a wall outlet plug? [ 2 Answers ]

I have a bedroom wall outlet plug that is currently switched on/off by an existing wall swtich. I want to set up that switch to turn a new ceiling light on/off and leave the wall plug controlled also by the wall switch. Is this possible and safe to have the existing wall switch control both the...

Replacing existing wall switch [ 2 Answers ]

I am replacing an existing toggle switch with a new dimmer. In the existing box, there are 2 white wires maretted together and not attached to the existing switch. There are 2 black wires screwed to the top screw of the existing switch and one red wire screwed to the bottom of the existing...

Wall switch controlling a outlet,want to use outlet to control ceiling fan [ 3 Answers ]

I Have a wall swich that currently controls a baseboard outlet. The Wall switch has a white,black, ground coming in from the top of the box-- and a white,black,red,ground coming in from the bottom of the box. The two blacks are tied together/two whites tied together... the red goes to the switch...

Dialing in a footing to to build a wall to close in an existing attached garage [ 1 Answers ]

I'm in nc an inspector called me and told me to dial in a footing where I'm going to build a wall. I might drill about 8 two foot long rods into the existing 18' long footing then lay two #5 continuous rods tied to the rebars. Put some visqueen down. Here in oxford nc carolina they want the footing...

Installing outlet from existing wall switch [ 12 Answers ]

I have a switch that controls an outside light. It is at the end of the run. I want to run an outlet inside the garage from that switch. I want the outlet to only have power when the switch is on. There are two black wires attached to the switch and the two white wires are connected with a wire nut...


View more questions Search