Ask Experts Questions for FREE Help !
Ask
    gitrdunmom's Avatar
    gitrdunmom Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 15, 2010, 02:55 PM
    Heating element cycles on and off even when thermostat is off
    The heating element in my mobile home furnace continues to cycle on every 10-15 seconds, even when thermostat is set to OFF position. Any suggestions on the problem?

Check out some similar questions!

In floor heating cycles on and off [ 1 Answers ]

My boiler turns on and off every few minutes while trying to get up to setpoint. The circulating pump continues to run until thermostat is satisfied. The pressure in the system runs at near 20 psi but when the pressure starts to drift towards Zero the boiler kicks on again. I drained some water out...

Intermittent heating cycles/thermostat inaccurate? [ 1 Answers ]

I am having problems with my heating system/thermostat.(7 yo Carrier gas) I have my thermostat set at 73 or 75. It does not hold that temp; drops to 68 and then the furnace kicks on to bring it to 73 or 75 again. Setting temp higher does not kick it on. I've had the repair person out twice already,...

Kenmore Thermostat/heating element installation [ 6 Answers ]

I have a Kenmore 70 series dryer (model #110.96576200) and have a bit of a problem. I removed a faulty heating element, threw it away without thinking of removing the thermostat. Now I've got a new heating element and a replacement thermostat and I can't figure out how it fits into the element? ...

Thermostat heating cycles [ 4 Answers ]

What can happen if I use a heat cycle of 5 versus 3. I bought two honeywell thermostats. RTH6300b. There is some confusion as to what heat setting to use. I have a new oil furnace, a system 2000 furnace with forced hot water. The thermostat says to use a setting of 5 if I have a gas or oil...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.