Ask Experts Questions for FREE Help !
Ask
    pep33333's Avatar
    pep33333 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 7, 2010, 10:23 AM
    Troubleshooting armstrong ultra vtech 80 furnace
    If I turn off my furnace and then back on it will start up and run fine for a while then stop working. Until I turn it off again and back on. What could be the problem
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Nov 7, 2010, 11:13 AM

    What does the fault code in the bottom door say?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Armstrong Ultra SX 80 furnace won't stay on [ 16 Answers ]

We have a Armstrong Ultra Sx80 furnace, model GUJ050D10-3A, with a HeatCraft Control Board, cat number 70k98 (40403001). Everything fires up fine… thermostat, inducer motor/fan starts, then ignitor, gas, and the burners light, etc. After the burners are lit for 30 seconds, the blower starts to...

Armstrong ultra sx-80 furnace problems [ 4 Answers ]

I have an armstrong ultra sx-80 gas furnace my problem is when I turn the unit on it will start up fine when I set it to heat, run for a few minutes then the flame dies. The blower stay on and will not shut off until I unplug the unit. The heat never reaches it's set point. If I wait for about 30...

Armstrong air ultra sx 80 furnace [ 7 Answers ]

I have an Armstrong Air Ultra sx 80 model# GUJ075D10-2B. The furnace has satisfied the call for heat and everything has shut off and waiting for the next call. The problem is on the start-up. When the igniter starts the flame, it is like there is a small build up of gas in the heat exchanger and...

Armstrong Ultra V Tech 80 furnace troubleshooting [ 0 Answers ]

My armstrong Ultra V Tech 80 furnace suddenly doesn't want to ignite. Please bear with me as I don't know a whole lot about furnaces. I can hear and see the gas come on, but it does not ignite. I can hear a clicking noise I assume is the ignitor trying to engage, but the furnace doesn't start. It...

Armstrong ultra sx 80 furnace no pilot light [ 3 Answers ]

We've had a problem the last 2 winters with our furnace, always fixed but last night the furnace stopped working. We checked and there was no pilot light. Actually in this model we don't even know where we would light it. Someone told me it might be the thermo couple but I am in need of another...

View more questions Search