Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue.
[ 11 Answers ]
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
Changing Thermostat Analog to Digital have 110 volt wires
[ 2 Answers ]
I have a baseboard hot water system with a gas boiler. Boiler is 6-7 years old. It has three zones with 3 separate pumps and thermostats. I checked the thermostat wires and they are 110 volts. Folks at the local hardware store I talked to were surprised with the 110 volts but suggested I could...
Changing Last Name
[ 1 Answers ]
My partner and I are planning to get married within the next year. However, neither of us wish to keep our current last name. Is it possible to create a new last name at the time of marriage and if so where could I find more information? We are living in Indianapolis, IN. I am a citizen and my...
Changing OS, ME to XP?
[ 1 Answers ]
Ok, I am considering finally getting ME off my system and going to XP. My system runs pretty good ( I try to keep it as clean and lean as possible) except for all the ME quirks that are well known: error screens, restarts, improper shutdows, software conflicts, etc. I was going to wait...
Changing Heat pump Thermostat.
[ 2 Answers ]
Currently have a Honeywell T841A1712 Multi-Stage Heat pump thermostat. I am changing to a Honeywell RTH7500D. All is good except that the manual states "If the old thermostat had wires on W1, Y1, and W2, some modification is required. Call your loca heating and cooling contractor for... View more questions Search
|