 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Heater Issue (CircuRay)
I have a large gas wall heater that says CircuRay. When it gets to where it should turn on, it just clicks once and makes a buzzing sound the whole time it should be on. I replaced the thermostat so that isn't the issue, but I guess it seems like it isn't lighting possibly?
Any ideas on how to troubleshoot this? |
||||
Check out some similar questions!
I recently replace my water heater with a tankless water heater. I purchase the Aquastar 250SX gas unit. The unit works great if I'm running hot water only. It will continuously give me hot water as long as I want it. However, when I want to reduce the tempurature by turning on the cold water,...
I have a question regarding relocating my water heater. I am trying to connect the piping in the new location but am running into a snag. The original installer used very short connections for the hot and cold coming out of the tank. Too short for me to cut and sweat on a coupling. So I would...
I have a marley heater 4 foot. On the heater is a double pole thermostat. There's 2 black wires and 2 red wires. 1 of the black wires reads cycle, the other black wire reads off. 1 of the red wires reads l1 and the other red wire reads l2. The power source coming to the heater is 2 black wires @...
I have replaced a hot water heater, and I used a 12/2 wire to provide my 240 volt service to the unit. Is the 12/2 wire safe? Do I need to use 10/2 wire? There appears to be no service problems with the 12/2 wire.
Hi I have GMP075-3 model of a Goodman gas furnace. The heater would make the sounds that it was beginning to work. I could see the ignitor light but then nothing else would happen. The repair guy came and said the Burner roll-out limit was somehow tripped the other day. Possibly from a down...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
