Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Upon installation of bulb, base of bulb burns and bulb never lights
[ 1 Answers ]
Installed two new 3 bulb post lights on concrete entry piers, one bulb pops and burns the base immediately upon installation... I have checked the wiring and everything is wired correctly, I assume ths is a bad bulb socket and the fixture is defective, has anyone had this problem before?
Does removing one bulb from a two bulb flourecent unit reduce cost?
[ 6 Answers ]
I am a General Manager for a company that has multiple large buildings. I have had it expressed to me by one of my investors that removing one of the two flourecent (32 Watt) bulbs from the unit will reduce cost by $30.00 a bulb a year! My simple understanding is that the ballast will run the same...
T3 bulb
[ 1 Answers ]
How di I change a t3 bulb?
Primer Bulb
[ 2 Answers ]
I have an older mower that runs OK. However, lately after about 10 min of running, it starts to choke out. When this happens, the primer bulb is sucked back into the mower. I can wait a few minutes or just manually pull the bulb back out and will run a few more minutes. What would cause the bulb to...
Three Way Bulb
[ 1 Answers ]
I Often Burn Out 3 Way Bulbs To One Way... and They Are Always New. What Am I Doing Wrong, Or How Can I Solve The Problem? YOU CAN FIND ME AT [email protected] THANKS ;) View more questions Search
|