 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Wher is the open high limit switch located on my trane xe 90
It's not iginting just blowing cold air. It turn on OK this morn and reach the temp set at but the blower kept running blowing cload air. The trubleshotting light flaces 4 times then pulses which means heat sensor switch open/open high limit device. What can I do?
|
||||
Check out some similar questions!
I have a Trane XR80 furnace that has an LED flashing 4 times--Open High Limit Device. The filters are new and clean, I replaced the high limit switch, cleaned the flame sensor. Are there other switches I could check? Any other ideas? Thanks for any help or ideas. Brian
Where is the high limit switch on a trane xe80
I was told by a Trane technician that either my high limit switch or the fan relay was causing my problems. The relay is on the control board, but where is the high limit switch
My furnace kicks the burner off when the fan starts. After 30 seconds the burner comes back on and then it runs through its cycle pretty much like it's supposed to. I was told by a Trane technician that it could either be the control panel orthe high limit switch. Where is the high limit switch...
Furnace is about 13 years old... we just replaced the ignighter in it last night because it was running through all the steps to run except ignighting. It fired right up and ran for about 7-8 hours... now it won't ignite at all (it is running through all the steps it needs to except for...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
