Payne inducer runs constantly

gander Posts: 1, Reputation: 1

New Member

Oct 16, 2010, 09:46 AM

Payne inducer runs constantly

Inducer motor running constantly with no previous codes. Diagnostic test lights igniter, runs blower, and quits leaving inducer running with no trouble codes and solid red led on Payne PG8MAA041100 Furnace. Furnace will not run normal heat or cool cycle from tstat.

Check out some similar questions!

Inducer (Draft) Motor constantly on - Lennox UHG80-100 [ 3 Answers ]

My furnace's draft motor never stops even after one full heating cycle, which it's supposed to stop! This causes the pressure switch to stay closed even after the thermostat calls for heat the second time (after the initial heat cycle). When I stop and start the main switch in my basement,...

How do I find a replacement tube that runs from inducer motor to pressure sensor [ 5 Answers ]

The tube has dry rotted I was able to shorten it to make the system work but I can't find a part # for a replacement.

Red Led Light constantly flashing on my 3Ton Payne Gas Furnace [ 0 Answers ]

Have a 3ton Payne Gas frunace... the Ignitor glows and the Gas Valve opens,the burners turn on,but after about a minute,the flame goes out and the Induced Draft motor shuts off.Only the blower stays running... the red led light keeps flashing... what is wrong? I replaced the ignitor,but the problem...

Inducer runs constantly [ 8 Answers ]

Thanks for taking the time to read the post. This is a trane xr90 gas furnace. The inducer fan runs constantly. The unit will run and meet the set point on the thermostat and then shut down except for the inducer fan running. The unit will not start again unless I manually reset the pressure...

View more questions Search

Check out some similar questions!

Add your answer here.