Ask Experts Questions for FREE Help !
Ask
    rollman's Avatar
    rollman Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 15, 2010, 07:36 AM
    I need to pull my pump that is in my well
    My question is I can see the connection where it is below the frost line how do I unhook that so I can get it up far enough to get my rope or strap attached? It looks like its made of gray plastic can I just pull on the electrical wire to get it started or do I need to unhook something where it comes out of the side under the frost line ?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Oct 15, 2010, 02:22 PM

    Sounds like you are looking at a pitless adapter. Check out this site. It might provide some help.

    Merrill MFG. :: About

    Pulling a submersible pump can be a load. Whatever you do, don't drop it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Snowblower won't start, made bad noise using electric, pull cord now hard to pull. [ 7 Answers ]

I tried to start my snowblower today and it wouldn't start. I decided to try the electric start, plugged it in, hit the start button and all it made was a spinny grinding noise. Unplugged it, and tried to start it manually with pull cord again. The cord would not pull without lots of effort and...

Pull Cord won't pull on my Briggs and Stratton 650 Series push mower [ 5 Answers ]

Ok here goes... The pull cord is stuck. Its pulls out about 4 inches then the cord stops. Looking into the cord area ontop of mower, I notice a small white plastic piece getting caught in a notch built into the cord housing. Now... when I loosen the cord a little bit, I can slide a butter knife...

Pull cord won't pull on Murray 2.0 mower [ 7 Answers ]

I have a Murray/Briggs 6.0 engine mower and the pull cord is sticking. It will stop after pulling about 4 inches. Then if I jiggle the pull cord it will extend another 4 inches. I can see a plastic piece that seems to be stopping it at every four inches. What is causing this and what is the repair...

What's the tool called that you losen up to pull up well head to change pump [ 1 Answers ]

Losen up the pitles adapter I think that's what its called

Ceiling fan light pull chain won't pull. [ 1 Answers ]

How do I fix a pull chain light switch that will not pull?

View more questions Search