 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trane xe 1200 with extra wire and no heat
Removed the original thermostat and replaced with a honeywell RTH6350 thermostat. Labeled all the wires and put them back into the correct place on the new thermostat. When I removed the old one, there was a purple wire not connected and the end covered in tape. Once I installed the new thermostat, I get A/C but now I am not getting heat. It is electric A/C and Gas heat. I do have a full tank of Gas and the valve at the unit is on. Any suggestions on why I can not get any heat from this unit?
|
||||
Check out some similar questions!
How do I distinguish the Trane XL-1200 as an air conditioner or a heat pump?
How to wire a trane 900 series thermostat to a five wire XL13i heat pump system.
I have a Trane XE 1200 Heat Pump and am trying to install a programmable Honeywell RTH7500 thermostat and have an extra wire. The previous thermostat was a manual Trane. I connected the Blue wire to the C terminal, the Yellow wire to the Y terminal, the Green wire to the G terminal, the Orange...
My Trane XE 1200 unit (2001) has really been struggling since the temperature has increased to the 90's. It works very hard to cool only a few degrees. The compressor is an outside unit and the air handler is in the attic. Today when I got home it took 2 hours to cool 3 degrees from 87 to 84. ...
My trane xl 1200 is stuk in heat. Will not go into cool. It is like the reverse vale is bad. Can you help me
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
