 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have 2 keeprite electronic ignition furnaces installed in1992.
The heat cuts out after 15-20 minutes and just blows cold air until I shut it off.I then press a very tiny reset button[roll out switch?] on the top side of a sensor located on a heat shield in front of the burning chamber.This will correct the problem temporarily.I justb installed 2 new ones but still have the same problem.I also have tried operating the furnaces with out the front covers and this did not make a difference.Any ideas?
|
||||
Check out some similar questions!
Having igniting problem. Just had a new gas valve(SV9500M 2682) installed, as old unit was not allowing gas flow to burners. However, now the pilot seems to fire randomly with different burner responses. I watch and see the burner in random order try to ignite all 4 tubes, but it seems like some...
I have a Coleman gas furnace with standing pilot light that I would like to convert to electronic ignition if possible. Model number is: 7655-856. If electronic ignition is not available, is there a high efficiency model that's a direct replacement?
I have a whirlpool gas range. Over the past two years the electronic ignition has stopped working approximately a dozen times. It may stay off a couple hours to a couple of days. Then for some reason it will start working. All connections apear good. What do you think the problem is?:(
My six year old, well maintained Caloric Gas Range has sealed burners and electronic ignitions to light the burners. I clean this critter regularly after each cooking session, but over the years, three of the four burners have ceased to light. They make the click-click sound, and I have to light...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
