 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Amana Gas Furnace Will Not Stay Lit
I have a furnace that is about 20 years old. When the furnace is first turned on everything works perfectly... it lights like it supposed to and runs for around 3-5 minutes then the burner shuts off and immediately tries to relight itself. It relights and the burner only runs for around 3 seconds before it goes out again. It tries relighting another two times and then just quits. I have cleaned and tested the flame sensor, and I have tested the pressure switch. If I like it cool completely back down and start the whole process over again it will run for 3-5 minutes again before it goes out and then will only relight for a couple of seconds. Does this sound like a problem with the fan limit switch? Please help me.
|
||||
Check out some similar questions!
I have a Rheem Criterion II gas furnace. It has been working this winter and went out this morning. The unit cycles, but the gas only stays lit for 7 secs. goes out, lights again for 7 secs. goes out, and then the blower turns on. I tried this with the thermostat turned to on as opposed to auto,...
We have an Amana furnace, model guc115c5oc, which does not stay lit. The unit will ignite, and then you hear several clicks ( which seem to be caused by the flame sensor for the rollback feature), and then the flame will turn off. It will try this about three times, and then the flame will shut...
OK so my gas lights but it will not stay on, already checked with the gas company and it should be OK. Any ideas?
I have an amana model plg8409w2 gas dryer. When I start it it will ignite. After a couple of minutes the flame goes out. A couple of minutes later the igniter will come on but the flame won't ignite. The dryer has worked flawlessly until now. It has been kept clean and all the wire connections...
I have a furnace that's about 30 yrs old. The pilot stays lit and it kicks on for about 30 seconds and then blows out along with the pilot light. We have vacuumed out the flue and the whole furnace with no results
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
