Colmen evcon # bgm075128 changed the thermostat now the burners will not light

Check out some similar questions!

Changed over from White Rodgers Thermostat to Honeywell thermostat [ 3 Answers ]

I have a White Rodgers 2 stage heat/1 cool model 1F58-58 heat pump thermostat that I have changed over to a Honeywell programmable thermostat model RTH7400. Did all the correct wiring as stated in the books but when set to cool, the heater kicks on instead of the central air conditioning. What...

Pilot is lit but burners will not light [ 7 Answers ]

I have a Fraser-Johnston closet mounted Natural gas using Central heating unit. The unit has been off all summer and I just changed the filters and relit pilot. When I set the thermostat I hear it click at the right temputure for it to turnon but the burners don't even try to light.. Could it be...

Intermittent pilot light burns well but main burners do not light [ 1 Answers ]

I have an Olson furnace with intermittent pilot light with electronic spark ignition. There is a Honeywell S8610U furnace controller. When thermostat calls for heat the ignitor sparks and the pilot flame lights. The flame continues to burn while the ignitor continues to spark for about 5+...

Burners won't light, or, stay lit [ 3 Answers ]

1'st time trying to turn heat on with new furnace-- hot surface ignition system -- burners don't light , or, stay lit -- can't tell which. Any special sequence needed to light? Any help appreciated

Changed from fan to light fixture and now light will not shut off [ 1 Answers ]

Today I tried to replace a ceiling fan to a light fixture. I connected the black to black white to white and copper to ground. I have a red wire that I don't know what goes to. The light now will not turn off. Should the red wire be connected to something?

View more questions Search

Check out some similar questions!

Add your answer here.