Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
My tub stopper is located outside of my tub on the floor; want to replace it - how?
[ 13 Answers ]
My stopper is tube shaped and has a lever at the top that you lift and lay to the side to release the water or lift and let fall in place to stop the tub up. This tube like device is located on the side of my tub and is set in the tile on my bathroom floor. It's the type of stoppers they used...
Tub drain over floor joist
[ 10 Answers ]
I am installing a new tub and wall unit and the new tubs drain lines up right over a floor joist. The old tub drain fit right down the side of the joist. There is about a 1.5" difference between the two tub drains. Any way to get around this without moving a floor joist?
Is there anything that goes between the tub itself and the cement floor?
[ 2 Answers ]
Is there anything that goes between the tub itself and the cement floor?
Tile trim for tub floor
[ 5 Answers ]
My first installer did not level the tub in new bathroom, among other things. Once his new tile job was taken down this was discovered, among other things again. Tub had to be pushed back about 3/4 inch, leaving gap on tile floor. Any ideas on how to fill this gap? Aside from ripping out the... View more questions Search
|