Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How to wire a 20 amp double pole breaker using 10/3 copper wire
[ 1 Answers ]
I have a water pump I would like to wire for 208 /220v. I have 10/3 copper wire. I need to wire the circuit breaker for the 208 / 220 v and connect the pump.
Snapped a copper pipe how do I fix it?
[ 1 Answers ]
Had an outside spigot that was busted tried to heat the joints up to remove and replace I turned the pipe wrench and the copper piping came out 4 inches into the brick wall but to get at the pipe to fix it I either have to take out a toilet to get to the wall the pipe is in from the inside or...
Can I use a single strand of lamp wire as the ground wire for a chandelier?
[ 2 Answers ]
I am in the process of rewiring a chandelier to lengthen the chain. I have wired it using a single strand of the insulated lamp wire as the ground - is this safe/ok to do instead of using the exposed copper wiring I typically see for the ground?
Attaching Copper wire to alum. Wire in fuse box.
[ 1 Answers ]
I have a electric stove to hook up in my house that had a gas stove. The electric 50 amp receptacle is already in place from the previous owner. The existing stove “aluminum” wiring goes into the circuit breaker box, but the wiring is cut off inside the circuit breaker box and is too short to...
How do I wire an antique chandelier?
[ 1 Answers ]
Hello, I have just purchased an antique chandelier. I am about to install it and have just realized that there is no colour differentiation with the wiring on the chandelier (i.e. no black/white wires). The chandelier has 2 off white coloured wires (assuming it's due to the age of the light). ... View more questions Search
|