Show the number of light bulbs in a circuit affect the current size

kerrygold Posts: 1, Reputation: 1

New Member

Sep 23, 2010, 08:57 AM

Show the number of light bulbs in a circuit affect the current size

tkrussell Posts: 9,659, Reputation: 725

Uber Member

Sep 23, 2010, 09:39 AM

You show the number of bulbs your talking about and the size circuit you have or plan to have.

Use more words to describe your situation.

Add your answer here.

Check out some similar questions!

Replaced a ballast and bulbs in fluorescent light fixture and now the bulbs flash [ 0 Answers ]

Replaced a ballast and bulbs in a fluorescent light fixture and now the bulbs flash what is causing this

Can I load a circuit with particular bulbs in mind? [ 6 Answers ]

Hi there again everyone, I'm setting up a living room and as had been discussed in this forum earlier, was told that a single circuit would be sufficient for a standard living room with my dimensions. It was also stated that 13 outlets(counting both light fixtures and recepts) would be the...

How do I choose wattage or # of bulbs or size or shade in bedroom ceiling light [ 1 Answers ]

What do I look for if I need a hangy down light like a pendant or chain to use in a bedroom center of the ceiling situation with a sloped ceiling and I want the light to point straight down, so can't go with flat flush mounted fixture because it follows the slope--where you flip a wall switch and...

Circuit breaker size for several 300 watt flood light [ 10 Answers ]

I like to install 4 sets of flood lights. Each set is a pair of 150 watts bulb, for a total Of 300 watts per set, for a grand total of 1,200 watts for all 4 sets. Can I put all 4 sets of flood ligts on a 15A circuit? This is the way I like to install them: 2 sets of flood lights for the back...

Lighting Circuit Blowing Bulbs [ 1 Answers ]

Hi, I'm in the process of repairing a DJ light system with a knackered transformer. It was causing the internal fuses to blow, so I've replaced the transformer, but it's now taken to blowing the bulbs within it. I'm guessing this is due to too high a voltage, or too much current flowing, but I...