The sping in my bathtub plug came out where do I put it back in?

_sab_ Posts: 1, Reputation: 1

New Member

Sep 22, 2010, 10:06 PM

The sping in my bathtub plug came out where do I put it back in?

My plug is one of those foot plugs... I need help please!

speedball1 Posts: 29,301, Reputation: 1939

Eternal Plumber

Sep 23, 2010, 05:05 AM

Originally Posted by ;

my plug is one of those foot plugs

And which one of these would it be? (see images) Let me know, Tom

Attached Images

Add your answer here.

Check out some similar questions!

What can I put in the bathtub to stop the water from draining while I take a bath? [ 1 Answers ]

Every time I get ready to fill the water in the tub, you can see the water going down slowly and eventually if I wait around too long my water will be drained all out from my tub. I have a little chip on the outer part on the metal part, it's not the part that you lift. The maintenance guy at my...

My Kemore ELite washer won't go into the sping cycle. [ 0 Answers ]

My Kenmore Elite top load washer won't go into the spin cycle. It makes kind of a small grinding noise. The washer is about 10 years old. Some have told me it's the transmission, and other said that the top dial on the washer is broken. It's draining the water, agitating for the clothes, but...

Hi guys, Where is a good place to put a plug for a septic pump and alarm ? [ 2 Answers ]

Just wondering where is the best spot to put my plugs for a septic tank pump and alarm? The tank will be right beside the house.

Back to back bathtub and shower backing-up in to each other [ 1 Answers ]

The house is a 1950's split level. I have a tub and shower that are back to back and when you run one, it backs-up in to the other. I have opened up the bathtub stopper and removed a lot of hair and grease using an auger. I have had a little trouble putting the bathtub stopper back in place where...

Bathtub drain plug screw [ 9 Answers ]

I am trying to remove the drain plug from my bathtub to make it easier to unclog. I have removed the top cap of the plug to expose a screw. I cannot get this screw loose. Is there a trick?