 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trane xl80 draft pressure problem
Vent fan starts,ignitor dark no flame,shut down. When I apply artificial vacuum on pressure switch during furnace start up, ignitor glows and burner flames. Before I buy new pressure switch what should I try? Don't think vents are blocked.
|
||||
Check out some similar questions!
My furnace was in 2ft. Of water for about 24 hours. I replaced the blower motor and start capacitor because it shorted out. The blower will still not start. The 120v/24v AC transformer and the 5 amp fuse in the blower compartment check okay. Should I assume that the circuit board is bad and needs...
I have a Trane XL80 Furnace. The blower doesn't seem to put out much force. I'm wondering if there is a way I can speed it up? In the winter it seems to do fine but in the summer it doesn't seem to keep up. I've replaced centeral air compressors since and have been told they are the right size but...
My Trane furnace is not putting out heat. Thermostat works, fan blows but burners are not lighting. Getting 3-flash error code, which, according to the manual is a Draft Pressure Error - possible problems, venting, pressure switch or inducer. I've turned off power, turned on. I've turned off...
The heater will run for awhile and then I will get the @ Flashes code! External Lockout (Retries or Recycles Exceeded) What will solve this problem? Dorsia
I have a Trane XL80 furnace, about 16 years old, with heat only setup. After we turned on the heat, the pilot fire came on, then the furnace lit and the heats up, however the blower wasn't turning and not blowing air. We opened both doors, saw the fan limit (a little round dial with setting to...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
