Check out some similar questions!

J Fritz · Dec 26, 2006, 09:42 PM

I have a Kenmore washer 110.82283 that is locked up. It is belt drive that the motor tries to run but the transmission pulley will only rotate about 1 degree with a distinct metallic clunk when I try to rock back and forth manually.

I tried to move the bars back and forth that appear to control the transmission but it remains locked.

Can this be anything other than the transmission? If so is this a common failure mode?

Thanks!!

J Fritz · Jan 2, 2007, 08:13 PM

Originally Posted by J Fritz

I have a Kenmore washer 110.82283 that is locked up. It is belt drive that the motor tries to run but the transmission pulley will only rotate about 1 degree with a distinct metallic clunk when I try to rock back and forth manually.

I tried to move the bars back and forth that appear to control the transmission but it remains locked.

Can this be anything other than the transmission? If so is this a common failure mode?

Thanks!!!

I guess I have to answer my own question. It turned out to be a bad bearing in the motor, there is a little side play in the shaft so I guess the balls are getting jammed and allowing about 5 degrees movement.