 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I'm wondering what options I have for outside supply and discharge? The appliance is a high efficiency York NG furnace (small, less than 60K BTU.). The installation manual shows what could just be PVC elbows. I'm wondering if there are other options. The furnace is intended as backup...
My furnace has a intermmitent problem. When it quits the fault code is open limit. They all are closed. I can get it to work by moving the wires at the control board connector. The connections appear to be OK. I looked at the rear of the board and did not see any bad solder joints or cracks....
If the thermocouple is defective, could you light the pilot and it and the burner would stay lit? How do you know it is defective? Would the defect be visible? If so, could you tell me What it would look like? The heater is 20+ years old. I have never had ONE problem with it, until I had it...
My Goodman furnace will light and then go out. This will occur 3 times, then will quit running. The control board blinks 1 time and tells me to Check Gas flow, gas pressure, gas valve, and flame sensor. It seems to have gas going to the valve. Could this be a bad gas valve? Or a bad Flame...
My gas furnace is approx. 30 years old. The furnace will run one cycle, shut off and approx. 15 seconds later run again for a shorter period. Everything is working properly, heating correctly etc. but runs two cycles. Any thoughts on why?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
