Ask Experts Questions for FREE Help !
Ask
    Clueless007's Avatar
    Clueless007 Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 12, 2010, 07:44 PM
    I had a seal on a pipe from the well to my shallow well pump blow out. Lost pressure
    I replaced the seal on the pipe from the well to the pump. The tank is full of air, and I think the water in is still in the pipe to the footvalve. If I remove the pressure gage, how much water is needed to get the pump primed? Do I need to let the air out of the tank?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
     
    #2

    Aug 13, 2010, 03:19 AM

    Do not bother the tank, other than making sure the pressure at the top valve is set at 2# below the cut in pressure. Might as well check that now that the system is, in effect, drained.

    Simply pour water into the opening at the top of the pump (where you unscrewed the gauge) until it it full, then replace the gauge.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Why am I losing water pressure inside only? On a shallow well, pump is fairly new. [ 4 Answers ]

Hi! I have a shallow well. We are in a drought. Water pressure is low throughout the house and falling, despite conserving water. I thought the problem was drought-related. But yesterday, I broke my self-imposed water restrictions and used the outside hose to water my thirsty shrubs. I was...

Shallow well pump pressure tank [ 2 Answers ]

Pump holds prime and found no leaks but after a few times we run the water or flush the toilet we lose water pressure and eventually lose water completely. Pump has a reset button and when we push that water returns but after each flush or two we have to keep hitting the reset button. We have to go...

New shallow well pump new huge pressure tank but water pressure is terrible [ 11 Answers ]

When I had a smaller pump (shallow well) and small tank my water pressure was great. When I had to replace everything the person installing the system put a bigger pump and a huge pressure tank. It is the size of a 50 gal water heater. I replaced everything. Ever since then my water pressure is...

Shallow pump with low pressure. [ 1 Answers ]

How I can increase the pressure from my shallow water jet pump?

Lost pressure to pump [ 1 Answers ]

We have an above ground water pump connected to an underground storage tank. We just had the tank filled, but there is no pressure in the pump. How do we re-prime to get it going again? Chuck


View more questions Search