Ask Experts Questions for FREE Help !
Ask
    LEE12345's Avatar
    LEE12345 Posts: 6, Reputation: 1
    New Member
    		  
    #1

    Jul 26, 2010, 02:33 PM
    Replacing goodman circuit board
    I have a goodman gmp 1004 gas furnace the old board has to be replaced pt#(18099-6)with a b18099-13 the wiring is not the same is there any thing that I showld look not to do before I attempt to install the new board I did mark every single wire when I took the old board
    Any help is greatly appreciated
    Lee
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jul 26, 2010, 07:53 PM

    Just be careful and don`t get your fingers on the printed circuits on the back, handle with TLC
    Salt or oil from your skin can cut down on the life of the board
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman circuit board arcs [ 3 Answers ]

My furnace blower will not run more then 1o seconds when it shut down I hear a click and a relay on the circuit boards has a arc what is the cause of it

Circuit board [ 3 Answers ]

In repairing an equipment that has a broken circuit board, you must ground yourself to the body of the equipment your working on to prevent what from damaging??

Help Replacing Carrier Circuit Board HK42FZ004 [ 2 Answers ]

I have a Carrier gas furnace that is not getting gas; the rest of the cycle runs properly, including the HSI glowing, but there is no gas to light, so the system shuts down and I get a 21 error code (gas lockdown). I am showing no voltage to the gas valve at the point in the cycle when control...

View more questions Search