Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacement Motor Wiring for condenser unit
[ 4 Answers ]
I have a Lennox HS16-461V-4P. The motor bearings died and I ordered a replacement motor. The old motor (GE) had two purple wires that went to and from the capacitor mounting in the unit. It also had orange and black wires that went to line voltage. The new motor (Emerson) only has three wires...
Trane condenser fan motor to A.O.Smith condenser fan motor
[ 2 Answers ]
The Condenser fan motor I removed from a Trane unit had four wires 1 black, 1red, 1brown and . The black wire went directly to #3 on the relay, the red wire went to the capacitor with black wire from #6 on the relay the brown wire went alone to the other side of the capacitor. I purchased...
Rheem RACB-030JAS residential A/C unit condenser fan motor replaced
[ 26 Answers ]
I just replaced the condenser fan motor and it initially spun up then stopped, after 10 minutes it ran again then stopped. Now I can hear it buzz then stop but not spin. The original motor was a GE 5KCP39BG K075CS 1/6 HP 1075 RPM 208/230 V its replacement a Dayton 4M205G 1/4 hp 1075 RPM ...
Condenser Fan Motor
[ 1 Answers ]
I have searched th web for a cross-match for a condenser fan motor for a RHEEM model RAKA-036JAS 3.0 Ton A/c Unit To no avail. R.S. R.Ph.
Condenser Unit Fan Motor
[ 2 Answers ]
Can I replace a 5. Inch body motor with a 3. Inch body motor, as long as the electrical specs are the same? The shaft on the 3. Inch body motor is longer, of course. Thanks. Dave View more questions Search
|