What should the natural gas pressure read at the meter

kevinquigley Posts: 1, Reputation: 1

New Member

Jun 28, 2010, 01:56 PM

What should the natural gas pressure read at the meter

What is the incoming gas pressure reading at the meter

KISS Posts: 12,510, Reputation: 839

Uber Member

Jun 28, 2010, 02:23 PM

After regulation at the meter around 1/2 PSIG.

Add your answer here.

Check out some similar questions!

Error code for "open pressure switch" on York natural gas furnace [ 6 Answers ]

I get three red flashes from the furnace after an attempt sequence when the t-stat calls for heat. The motor starts, and seems to try to light but after about thirty seconds, it quits and gives the error code. I have removed both gray tubes from the pressure switch and made sure they are...

Residential natural gas line pressure test [ 1 Answers ]

What would be a reasonable cost to have a residential gas system pressure tested downstream from the gas meter. There is a gas furnace, a gas water heater and a gas range on the system. The piping for residential pressure test shall stand a pressure of not less than three (3) pounds per square...

How to check natural gas pressure at furnace [ 3 Answers ]

How do I check gas pressure into my house?

Capacity of 6" schedule 40 pipe at 3 psi. Natural gas pressure [ 1 Answers ]

Capacity of 6" schedule 40 pipe at 3 psi. And, where can I find a pressure table for capacities of various size pipes at various inlet pressures

What is the avg. Gas p.s.I. From gas meter on the residentcial side of meter [ 2 Answers ]

What is the avg. gas p.s.I. from gas meter on the residentcial side of meter. I think its 5 lbs. I live in Los Angeles, don't know if it changes from state to state.:eek: