HR6 auto a/c compressor

weldonbehrens Posts: 3, Reputation: 1

New Member

Jun 25, 2010, 11:52 AM

HR6 auto a/c compressor

Have HR6 compressor with offset level suction/discharge ports. Hose suction/discharge block is flat. Does the small end of sealing insert go into compressor or hose block.

Check out some similar questions!

Heat pump outdoor fan runs not compressor voltage at compressor good. New compressor [ 1 Answers ]

Have a new compressor. Just replaced fan runs compressor does not, have voltage at the compressor plug? What could stop from coming on high side and low side equal at 100psig.

AC blower fan will not run in auto, only "ON". (heater runs in auto fine). [ 2 Answers ]

AC problem. My blower fan will not run in auto. (heater runs in auto fine). The fan will run in "on" position. I suspect the timer (or maybe a limit switch if there is one) on the fan control board. Does anyone know where I can get a schematic for the Lennox BCC2 fan control board? Thanks...

Amana air conditioning compressor fan runs but compressor does not [ 9 Answers ]

I have an Amana Model RCE30A2B Compressor unit installed it is about 6 years old, the compressor will not cut in when demanded yet the cooling fan for the unit does

Auto reposession/Default on Auto Loan [ 3 Answers ]

To whom could lend some immediate advice, I purchased a 2005 brand new vehicle in 2005. This automobile has been repossessed as of 5/07. In addition, I filed bankruptcy (Chapter 13) in 2006 to avoid this very problem, however that has been dismissed for lack of payments. My current...

View more questions Search

Check out some similar questions!

Add your answer here.