Ask Experts Questions for FREE Help !
Ask
    morenopenalba's Avatar
    morenopenalba Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 21, 2010, 03:23 AM
    My mazda tribute v6 model 2004 ignition light indicator is always on for about 10 to 1
    My mazda tribute v6 model 2004 ignition light indicator is always on for about 10 to 15 minutes. I have it check and it shows that my alternator is not charging. It will only charge after the ignition(battery indicator) turns off. What do I do?

Check out some similar questions!

Fog bulb replacement on a 2003 Mazda Tribute ES [ 0 Answers ]

I own a 2003 Mazda Tribute ES 6 cylinder. One of the fog lights has burned out. Visited a Mazda dealer service shop and they quoted me a price for the bulb replacement for about $80 bucks. C'mon, a bit much to replace a bulb! Does anyone know how to replace this type of bulb? Are special tools...

Mazda tribute won't do anything [ 2 Answers ]

Hi, I have a madza tribute v6, and this morning it just stopped in the middle of the road, anyway you can turn on the switch but the fuel pump won't pump up and nothing will happen when you turn the key to start, I checked to see if the starter relay was getting what it was suppose to and it was, I...

"sticky" hazard light button on a '03 Mazda Tribute [ 1 Answers ]

My daughter owns a 2003 Mazda Tribute. The hazard light button tends to stick when depressed and the hazard lights cannot be turned off. Recently, this problem trained the battery charge, which after being jumped is just fine. However, a paper clip is now forced into the hazard button to prevent it...

Replacing spark plugs on '03 Mazda Tribute ES [ 1 Answers ]

I own a 2003 Mazda Tribute ES 6 cylinder with 60k. I have noticed lately that my miles/gal. seems to be decreasing. I thought that I would attempt to replace the plugs myself however I don't know where they're located!! Can't even find the spark plug wires. Can I possibly be that ignorant? Are...

2001 Mazda Tribute [ 2 Answers ]

I just replaced the upper and lower intake manifold gaskets on my mazda, in addition to the pcv valve, spark plugs and the corroded vacuum lines. I used fuel injector spray cleaner to clean the throttle body also. I started it up and it ran a little rough at first, but then cleared up was...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.